DocuColor 5000 User Guide
4-35
4. Accessories
Fault Code 112-130
Jam indicated in
stacker/stapler, but is
also in Exit Module.
Paper is jammed over
both the Exit Module and
stacker/stapler sensors.
• Open the stacker/stapler door.
• Clear any visible jams.
• If no jammed paper is visible in the stacker/stapler
area indicated, open the Exit Module door and
clear any jammed paper. Close the Exit Module
door.
• Open and close the stacker/stapler door.
Fault Code 112-130
Jam indicated in
stacker/stapler.
Paper is jammed
between the
Exit Module and the
stacker/stapler sensors.
• Open the stacker/stapler door.
• If no jammed paper is visible in the area indicated,
open the Exit Module door and clear any jammed
paper. Close the Exit Module door.
• Open and close the stacker/stapler door.
• If the fault persists, undock the stacker/stapler and
clear the jammed paper between the Exit Module
and the stacker/stapler. Refer to the Note below
this table for information on how to undock the
stacker/stapler.
Fault Code 112-110 Paper jammed in the
stacker/stapler and the
Exit Module during a
purge of sheets to the
Top Tray.
• Clear the jammed paper from the stacker/stapler.
• Clear the jammed paper from the Exit Module.
• Open and close the stacker/stapler door.
• Resume job.
Fault Code 052-310 Communication problem • Cancel or save the job.
• Power off the digital press. Wait 15 seconds and
power on.
Fault Code 052-321 Connection problem • Cancel or save the job.
• Power off the digital press. Wait 15 seconds and
power on.
Fault Code 052-320 Unexpected connection • Cancel or save the job.
• Power off the digital press. Wait 15 seconds and
power on.
Fault Code 052-312 Communication problem • Cancel or save the job.
• Power off the digital press. Wait 15 seconds and
power on.
Ready Indicator does
not illuminate
No power • Check the power cord connected to the power
source.
• Check that the main switch is on.
Problem Cause Solution
To Next Page
Loading...
Need help?
General