Xerox WorkCentre M20 - Page 109

December 2006
4-11
WorkCentre M20, 4118, FaxCentre 2218 Family
REP 1.7
Repairs and Adjustments
3. Remove the IPR - shield SMPS upper, Figure 1.
Figure 1 IPR - shield SMPS upper removal
4. Disconnect CON2 from the SMPS.
5. Disconnect CON52 and CON53 from the SMPS - PSP fuser.
6. Remove the SMPS - PSP fuser, Figure 2.
Figure 2 SMPS - PSP fuser removal
Replacement
Replacement is the reverse of the removal procedure.
1
Disconnect 2 ground
harnesses
2
Remove 1 screw, then the
IPR - shield SMPS upper.
1
Remove 4 screws, then
the SMPS - PSP fuser.