Xerox WorkCentre M20 - REP 8.5 MEA Unit - Feed Roller Assembly

December 2006
4-44
WorkCentre M20, 4118, FaxCentre 2218 Family
REP 8.4, REP 8.5
Repairs and Adjustments
5. Remove the ELA HOU - MP assembly, Figure 4.
Figure 4 ELA HOU - MP assembly removal
Replacement
Replacement is the reverse of the removal procedure.
REP 8.5 MEA Unit - Feed Roller Assembly
Parts List on PL 8.15
Removal
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
CAUTION
Before performing this procedure, refer to General Disassembly Precautions, GP 10.
NOTE: If necessary, refer to GP 20 for the acronym list and cross reference lists of more com-
monly recognised part names.
1. Remove the ELA HOU - MP assembly, REP 8.4.
2. Pull out the tray 1 cassette assembly approximately 100mm (4 inches).
3. Prepare to remove the MEA unit - feed roller assembly, Figure 1.
Figure 1 Preparation
1
Release the harness.
2
Unclip the ELA HOU - MP
assembly by releasing the
two clips from under the
machine.
3
Remove the ELA HOU -
MP assembly.
1
Remove 3 screws.