Xerox WorkCentre M20 - REP 8.1 ELA HOU - Side Cover Assembly

December 2006
4-41
WorkCentre M20, 4118, FaxCentre 2218 Family
REP 8.1
Repairs and Adjustments
REP 8.1 ELA HOU - Side Cover Assembly
Parts List on PL 8.10, PL 8.11 and PL 8.13
Removal
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
CAUTION
Before performing this procedure, refer to General Disassembly Precautions, GP 10.
NOTE: If necessary, refer to GP 20 for the acronym list and cross reference lists of more com-
monly recognised part names.
NOTE: The M20F, 4118 and 2218 procedures are the same. The M20F is shown in Figure 1
and Figure 2.
1. Prepare to remove the ELA HOU - side cover assembly, Figure 1.
Figure 1 Preparation
2. Fully open the ELA HOU side cover assembly. Remove the ELA HOU - side cover
assembly, Figure 2.
Figure 2 ELA HOU - side cover removal
Replacement
Replacement is the reverse of the removal procedure.
1
Remove 2 screws.
2
Disengage both PMO - tie
stoppers.
1
Disengage the front
hinge.
2
Disengage the rear
hinge.
3
Remove the ELA HOU - side
cover assembly.