Xerox WorkCentre M20 - GP 4 Fax Setup; GP 5 Memory Clear

December 2006
6-26
WorkCentre M20, 4118, FaxCentre 2218 Family
GP 4, GP 5
General Procedures and Information
GP 4 Fax Setup
Purpose
To give details of the fax setup that can be selected in service mode, GP 3. Refer to Dial Mode.
Dial Mode
Select the dialing mode according to the users line status:
• TONE: Electronic dialing (modern systems).
• PULSE: Mechanical dialing (older systems).
GP 5 Memory Clear
Purpose
To give details of the memory clear procedure that can be performed in service mode, GP 3.
Refer to Clear All Memory.
Clear All Memory
This function resets the system to the default factory setting. All the values will be returned to
default values, and all the information, which has been set by the user, will be lost. A memory
clear must be performed if a new main PBA has been installed. Perform the relevant proce-
dure:
• M20F Procedure
• 4118/2218 Procedure
M20F Procedure
Perform the following:
1. Enter service mode, GP 3.
2. Select ‘MEMORY CLEAR’.
3. Press the ENTER button.
4. Select the relevant country.
5. Press the ENTER button.
4118/2218 Procedure
Perform the following:
1. Enter service mode, GP 3.
2. Select ‘MAINTENANCE’.
3. Press the ENTER button.
4. Select the ‘MEMORY CLEAR’.
5. Press the ENTER button.