December 2006
v
WorkCentre M20, 4118, FaxCentre 2218 Family
Introduction
• Wiring Diagram 9 (4118)
• Wiring Diagram 10 (4118)
• Wiring Diagram 11 (4118)
• Wiring Diagram 12 (4118)
• PWB Connector Locations
• Change Tags
• ACC 2 Foreign Device Interface Installation
The following bulletins, ETI and TIPs are included.
• ETI 189796 C20 techmode flowchart
• ETI 208283 Faint or blank copies / DADF pause 10 sec. before feeding
• ETI 208756 Paper jam 2 message
• ETI 208972 Paper jam 0 paper does not feed from tray
• ETI 214834 Noise and toner spill
• ETI 234008 Duplex jams and grinding noise
• ETI 240382 Tray 2 module will not feed paper
• ETI 243009 Side edge registration adjustment from DADF only
• ETI 260720 DADF lead edge offset
• ETI 284873 Copy output ‘indentation’ damage
• ETI 285328 Dead machine F1 blown
• ETI 322931 Noise that is hard to pin down / noisy ROS (LSU)
• ETI 332890 Bands or streaks across copies / Internal prints OK
December 2006
The FaxCentre 2218 has been introduced. This is a variation of the WorkCentre 4118 with
improved Fax features. Throughout this manual, procedures and parts that are unique to either
the WorkCentre M20 family, the WorkCentre 4118 family or the FaxCentre 2218 will be desig-
nated M20F, 4118 or 2218.
The following procedures are updated
• SCP 7 Machine Configurations and Options
• 1.1 Power Failure RAP
• 5.1 Load Document RAP
• 5.2 Document Jam RAP
• 6.1 LSU Error RAP
• 8.1 Door Open RAP
• 8.2 Bypass Jam RAP
• 8.3 Duplex Jam RAP
• 8.4 Paper Jam 0 Open/Close Door RAP
• 8.5 Paper Jam 1 Open/Close Door RAP
• 8.6 Paper Jam 2 Check Inside RAP
• 8.7 No Paper Add Paper RAP
• 8.8 Tray 2 Not Detected RAP
• 9.1 Install Cartridge RAP
• 9.2 Non-Xerox Toner Cartridge RAP
• 9.4 Replace Drum RAP
• 9.5 Toner Empty RAP
• 10.1 Low Heat Error RAP
• 10.2 Open Heat Error RAP
• 10.3 Over Heat Error RAP
• 20.1 Fax Error Messages RAP
• 20.3 Fax Faults Without a Message RAP
• OF3 Use Auxiliary Access RAP
• OF4 Audible Noise RAP
• IQ2 Blank Copies RAP
• IQ3 Black Copies From the Scanner RAP
• IQ4 Blurred Image From the Scanner RAP
• IQ5 Vertical Black Lines or Bands RAP
• IQ7 Light Image RAP
• IQ8 Dark Image RAP
• IQ9 Background RAP
• IQ10 Ghost Images RAP
• IQ12 Poor Fusing RAP
• IQ15 Different Image Density (Left and Right) RAP
• IQ 16 Horizontal Bands RAP
• IQ19 DADF Lead Edge Offset RAP (M20F/2218)
• IQ20 Poor Side Edge Registration RAP
• REP 1.3 PBA Main (4118/2218)
• REP 1.4 HVPS (4118/2218)
• REP 4.1 ELA HOU - Drive Assembly
• REP 4.3 PMO Cover Exit Rear
• REP 4.4 ELA HOU - Frame Main Assembly
• REP 5.1 ELA HOU - DADF (M20F/2218)
• REP 6.1 Unit - LSU
• REP 8.1 ELA HOU - Side Cover Assembly
• REP 8.4 ELA HOU - MP Assembly
• REP 8.6 ELA HOU - Pickup Assembly
• REP 10.1 ELA HOU - Fuser Assembly
• REP 10.2 MEC - Exit Assembly
• ADJ 5.1 DADF Side Edge Registration Adjustment (M20F/2218)
•Parts List
• GP 2 User Mode Entry
• GP 3 Service Mode Entry
• GP 11 Machine Specifications
• GP 12 Circuit Description
• GP 20 Acronyms and Parts Description List
• Wiring Diagram 6
• Wiring Diagram 8 (4118/2218)
• Wiring Diagram 11 (4118)
To Next Page
Loading...
