1-4
GEN
INFO
E
SAFETY WHILE WORKING
3.
Non-reusable items
When reassembling, always use new
gaskets, packing, O-rings, oil seals,
split-pins and circlips, etc.
DISASSEMBLY AND ASSEMBLY
1. Clean parts with compressed-air when
disassembling them.
2. Oil the contact surfaces of moving parts
before assembly.
3. After assembly, check that moving parts
operate normally.
4. Install bearings with the manufacturer’s
markings on the side exposed to view
and liberally oil the bearings.
5. When installing oil seals, apply a light
coating of water-resistant grease to the
outside circumference.
To Next Page
Loading...
