Yamaha 60F - Cylinder Head Bolts, Engine Mounting Bolts, and Flywheel Nut; Fuel Filter; Fuel Tank and Fuel Line

3-4
INSP
ADJ
E
PERIODIC SERVICE
(75, 80, 90 hp)
1. Loosen the idle adjust screw and fully
close the throttle valve.
2. Loosen the throttle lever securing
screws of upper and lower carburetors
by turning clockwise.
3. While lightly pushing the throttle lever
of the middle carburetor in the direction
of the arrow (full-closed), tighten the
throttle lever securing screw of the
upper and lower carburetors by turning
counterclockwise.
1 Idle adjust screw
2 Throttle lever
3 Throttle lever securing screw
D32000-0
CYLINDER HEAD BOLTS, ENGINE
MOUNTING BOLTS, AND FLYWHEEL
NUT
1. Retighten to specifications.
2. Check other fixings and tighten if neces-
sary.
D32300-0
FUEL FILTER
Clean the strainer of dust and impurities.
1 Strainer body
2 Strainer
3 O-ring
4 Strainer cup
D32600-0
FUEL TANK AND FUEL LINE
1. Check the fuel tank and fuel line for
leaks.
2. Clean the fuel tank thoroughly.