3-1
INSP
ADJ
E
PERIODIC SERVICE
D30000-1*
PERIODIC SERVICE
MAINTENANCE SCHEDULE
The following chart may be taken as a helpful guide to the intervals between maintenance
procedures.
Intervals
Item
Initial Every
Refer
page
10 hours
(Break-in)
50 hours
(3 months)
100 hours
(6 months)
200 hours
(1 year)
Anode 3-1
Battery
(every month)
3-2
Carburetor
3-3
Carburetor link
Cylinder head bolts,
engine mounting bolts,
and flywheel nut
3-4
Fuel filter
3-4
Fuel tank and fuel line
Gear oil
3-5
Idle-speed
Ignition timing 3-6
Oil injection pump 3-10
Oil level warning system 3-11
Oil pump link
3-12
Power trim and tilt system
Propeller
3-13
Spark plug
D31000-0
ANODE
Inspect the anode. If it is worn out, replace
it with a new one. If scaling of the surface is
evident, remove the anode, clean it with a
wire brush and remove all trace of oil or
grease. After cleaning, polish the contact
surfaces of the anode mount and re-install.
CAUTION:
Never paint the anode. To ensure good
electrical contact, keep the anode contact
surface clean of oil or grease.
To Next Page
Loading...
