Yamaha F40BWHD - Checking the Engine Oil Level; Replacing the Engine Oil and Oil Filter; Power Unit

CHK
ADJ
3-12
CONTROL SYSTEM/POWER UNIT
E
NOTE:
Shift into neutral and make sure the starter
can be pulled. If it cannot be pulled, repeat
the above procedure.
POWER UNIT
CHECKING THE ENGINE OIL LEVEL
Check:
• Engine oil level
Above → Check for fuel in the engine oil.
Below → Add engine oil so that
the level is between and .
REPLACING THE ENGINE OIL AND OIL
FILTER
1. R e m ov e :
• Oil filter cap
• Drain plug
2. Remove:
• Oil filter
3. Install:
• Drain plug
4. Install:
• Oli filter
NOTE:
Lubricate the rubber seal with engine oil
before installation.
a
b
a
b
a b
1
3
2
Oil filter wrench
YU-38411/90890-01426
T
R
.
.
Drain plug
18 Nm (1.8 m
•
kgf, 13 ft
•
lb)
T
R
.
.
Oil filter
17.5 Nm (1.8 m
•
kgf, 13 ft
•
lb)
1
2
3
3