BRKT
7-28
TILT CYLINDER ASSEMBLY
E
ASSEMBLING THE TILT CYLINDER
ASSEMBLY
1. Install:
• Free piston
NOTE:
Push the free piston down until it is fully
compressed at the bottom of the tilt cylin-
der.
2. Fill:
• Tilt cylinder
NOTE:
Fill the cylinder with Power trim and tilt
fluid. Add Power trim and tilt fluid until it is
approximately 15 mm below the last thread
on the cylinder as shown.
3. Install:
• Tilt ram assembly
NOTE:
When installing the tilt ram assembly.,
make sure that the tilt ram is fully extended.
4. Tighten:
• Tilt cylinder end screw
15 mm
a
1
2
Recommended Power trim and tilt
fluid
ATF Dexron II
1
a
2
Tilt cylinder wrench
YB-06175-2B/90890-06544
T
R
.
.
Tilt cylinder end screw
90 Nm (9.2 m
•
kgf, 66.4 ft
•
lb)
To Next Page
