6 - 44
CHAS
8. Install:
• throttle cable 1
• throttle grip 2
• throttle cable housing (front side) 3
NOTE:
_
• Lubricate the inside of the throttle grip with a
thin coat of lithium-soap-based grease and
install it onto the handlebar.
• Align the projection a on the throttle cable
housing (front side) with the hole b on the
handlebar.
9. Install:
• throttle cable housing (rear side) 1
WARNING
_
Make sure the throttle grip operates
smoothly.
10.Adjust:
• throttle cable free play
Refer to “ADJUSTING THE THROTTLE
CABLE FREE PLAY” in chapter 3.
11.Adjust:
• brake lever free play
Refer to “ADJUSTING THE REAR BRAKE”
in chapter 3.
Throttle cable free play (at the
flange of the throttle grip)
3 ~ 7 mm (0.12 ~ 0.28 in)
Brake lever free play (lever end)
10 ~ 20 mm (0.39 ~ 0.79 in)
HANDLEBAR
To Next Page