Yamaha XT250X - Page 188

OIL PUMP AND BALANCER GEAR
5-42
● Assemble the dowel pin on the spring as
shown.
6. Install:
● Balancer driven gear “1”
● Lock washer
● Balancer driven gear nut
NOTE:
Align mark “a” of the balancer drive gear with
mark “b” of the balancer driven gear.
7. Tighten:
● Primary drive gear nut
Refer to “CLUTCH” on page 5-30.
8. Tighten:
●
Balancer driven gear nut “1”
NOTE:
Insert aluminum plate “a” between balancer
drive gear “2” and balancer driven gear “3”, and
tighten the balancer driven gear nut.
9. Be sure to bend the lock washer tab along to
the nut side face.
Balancer driven gear nut
55 Nm (5.5 m•kg, 40 ft•lb)
3
2
4
b
a
1
New
T
R
.
.