Yamaha XT250X - GENERATOR AND STARTER CLUTCH

GENERATOR AND STARTER CLUTCH
5-45
EAS3C51010
GENERATOR AND STARTER CLUTCH
Removing the generator rotor and starter clutch
Order Job/Parts to remove Q’ty Remarks
Drain the engine oil
Refer to “CHANGING THE ENGINE OIL” on
page 3-11.
Rear left side cover
Refer to “GENERAL CHASSIS” on page
4-1.
Drive sprocket cover Refer to “CHAIN DRIVE” on page 4-57.
Shift pedal assembly Refer to “ENGINE REMOVAL” on page 5-1.
1 Pickup coil coupler/stator assembly coupler 1/1 Disconnect.
2 Starter clutch Idle gear cover 1
3 Starter clutch idle gear1 1
4 Starter clutch idle gear shaft1 1
5 Generator rotor cover 1
6 Generator rotor cover gasket 1
7 Dowel pin 2
8 Stator assembly 1
9 Starter clutch idle gear2 1
10 Starter clutch idle gear shaft2 1
11 Generator rotor 1
12 Woodruff key 1
13 Starter clutch gear 1
New
New
New
New
LT
LT
E
LT
E
LT
New
E
T
R
.
.
10 Nm (1.0 m • kg, 7.2 ft • Ib)
T
R
.
.
30 Nm (3.0 m • kg, 22 ft • Ib)
T
R
.
.
60 Nm (6.0 m • kg, 43 ft • Ib)
T
R
.
.
10 Nm (1.0 m • kg, 7.2 ft • Ib)
T
R
.
.
8 Nm (0.8 m • kg, 5.8 ft • Ib)
T
R
.
.
10 Nm (1.0 m • kg, 7.2 ft • Ib)
T
R
.
.
7 Nm (0.7 m • kg, 5.1 ft • Ib)
1
2
3
4
5
6
8
9
(5)
(3)
(3)
(3)
7
10
11
13
14
12
15
(3)