Yamaha XT250X - CRANKCASE

CRANKCASE
5-54
EAS25540
CRANKCASE
Separating the crankcase
Order Job/Parts to remove Q’ty Remarks
Engine Refer to “ENGINE REMOVAL” on page 5-1.
Piston
Refer to “CYLINDER AND PISTON” on
page 5-25.
Balancer drive gear
Refer to “OIL PUMP AND BALANCER
GEAR” on page 5-38.
Shift shaft Refer to “SHIFT SHAFT” on page 5-43.
Generator rotor
Refer to “GENERATOR AND STARTER
CLUTCH” on page 5-45.
1 Timing chain guide (intake side) 1
2 Timing chain 1
3 Crankshaft sprocket 1
4 Straight key 1
5 Speed sensor 1
6 Speed sensor rotor 1
7 Neutral switch 1
8 Right crankcase 1
9 Dowel pin 2
10 Left crankcase 1
For installation, reverse the removal proce-
dure.
New
New
New
New
LT
LT
T
R
.
.
8 Nm (0.8 m • kg, 5.8 ft • Ib)
T
R
.
.
10 Nm (1.0 m • kg, 7.2 ft • Ib)
T
R
.
.
10 Nm (1.0 m • kg, 7.2 ft • Ib)
T
R
.
.
20 Nm (2.0 m • kg, 15 ft • Ib)
5
8
9
10
7
9
6
1
2
3
4