1. Stand the vehicle on a level surface.
WARNING
EWA13120
Securely support the vehicle so that there is
no danger of it falling over.
2. Elevate:
● Front wheel
NOTE:
Place the vehicle on a suitable stand so that the
front wheel is elevated.
EAS21930
CHECKING THE FRONT WHEEL
1. Check:
● Front wheel axle
Roll the wheel axle on a flat surface.
Bends → Replace.
WARNING
EWA13460
Do not attempt to straighten a bent wheel ax-
le.
2. Check:
● Tire
● Front wheel
Damage/wear → Replace.
Refer to “CHECKING THE TIRES” on page
3-23 and “CHECKING THE WHEELS” on
page 3-24.
3. Check:
●
Spokes
Bends/damage → Replace.
Loose → Tighten.
Refer to “CHECKING AND TIGHTENING
THE SPOKES” on page 3-25.
NOTE:
After tightening the spokes, measure the front
wheel runout.
4. Measure:
● Front wheel radial runout “a”
● Front wheel lateral runout “b”
Over the specified limits → Replace.
5. Check:
● Collars
Damage/wear → Replace.
6. Check:
● Wheel bearings
Front wheel turns roughly or is loose → Re-
place the wheel bearings.
● Oil seals
Damage/wear → Replace.
EAS21910
DISASSEMBLING THE FRONT WHEEL
1. Remove:
● Oil seals
● Wheel bearings
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Clean the outside of the front wheel hub.
b. Remove the oil seals “1” with a flat-head
screwdriver.
NOTE:
To prevent damaging the wheel, place a rag “2”
between the screwdriver and the wheel surface.
Radial wheel runout limit
2.0 mm (0.08 in)
Lateral wheel runout limit
2.0 mm (0.08 in)
a
b
To Next Page
