B95W
Maintenance
06_Wartung und Pflege_en.fm - V1.0 - 1.8.17
113 / 306
6
20
When cleaning with a steam-jet appliance, the hot water jet should not
exceed 80 °C and a spray pressure of 70 bar. Stand clear by at least 1 m.
Keep any third parties clear of the machine’s danger zone.
Linings (insulating materials, etc.) should not be exposed directly to water,
steam or high-pressure jets.
When cleaning with water or steam jets, do not direct the jet into exhaust and
air filter openings.
When cleaning the engine with water or steam jet, do not expose sensitive
engine parts, such as generator, wiring, oil pressure switches, etc. directly to
the jet.
When cleaning, ensure that no components are damaged (e.g., bent radiator
grilles).
Cover any electrical/electronic components and connectors when cleaning
the engine.
Clean any mud, snow or ice from the machine.
After wet cleaning, always lubricate the machine as specified in the lubrication
plan and check all operating cycles and support and travel functions.
Only clean the engine compartment when the engine is cool and do not let
the high-pressure jet clean electrical components directly.
Cold-cleaning the engine: Spray cold-cleaning agent on the engine and let it
work for 10 minutes. Then spray the engine clean with a strong water jet.
Finally, turn on the engine to let the heat evaporate any remaining water.
Finally, clean the washing area.
The operator is responsible for managing the cleaning area and ensuring that
any waste water is disposed of in an environmentally friendly way.
To Next Page
Loading...
