B95W
Operation
07_Bedienung_en.fm - V1.0 - 1.8.17
205 / 306
7
26
7 Operation
7.1 Before operation
The section “Operation”. describes all functions for operating the machine.
Familiarize yourself with the display and control elements before driving or
starting work.
J See chapter 5.3 “Display and control elements in the operator's compartment”.
Familiarize yourself with the control levers and pedals.
J See chapter 5.3 “Display and control elements in the operator's compartment”.
Acquaint yourself with the keypad and display.
J See chapter 5.3.3 “Keypad”.
J See chapter 5.3.4 “Display”.
Thoroughly inspect the machine visually before each start-up. Watch out for
damage, loose or missing screws, oil deposits, and oil or fuel leaks.
Any faults must be immediately rectified.
If the operational safety of the machine is at risk, you must only start operation
after the faults have been eliminated.
Switch on the battery isolator switch.
Notice
Strictly observe all safety notes.
See chapter 3.7 “Operation”.
Risk posed by incorrect operation
The machine may move unexpectedly.
Danger of serious injury and death.
Z Familiarize yourself with all display and control elements
before you start excavating. See chapter 5.3.1 “Controls”.
Notice
An initial inspection must be carried out before commissioning.
See chapter 6.6.1 “Initial inspection (delivery inspection)”.
To Next Page
Loading...
