B95W
Operation
250 / 306
7
07_Bedienung_en.fm - V1.0 - 1.8.17
26
7.5.3 Using the machine for hoisting
When using the machine for hoisting, the safety notes must be observed.
J See chapter 3.20 “Hoisting operation”.
Loads may only be fastened which do not exceed the lifting capacities of the
machine and the lifting gear.
J See chapter 9.2.12 “Load capacities”.
Turn on the oscillating axle lock.
J The indicator light in the switch lights up red.
Overload
warning device
The permitted load of the machine must not be exceeded.
During operation, keep an eye on the display of the overload warning device.
The integrated overload warning device cannot fully rule out the possibility of
accidents due to incorrect operation.
This is particularly true with regard to the following:
• Bottom hook of the load or lifting gear
• Excessive delay or acceleration forces (hard braking or a strong start to the
slewing action with the load being moved)
• A load falling against the cable
• Pulling up at an angle
• Moving the machine to an area where the ground slopes more
• Wind load
Avoid these hazards by using the machine cautiously and prudently.
Risk posed by overload
Risk of machine damage
Z Machines may only be used for hoisting if they are equipped
and approved for such work.
Z The permitted load of the machine must not be exceeded.
Z Observe the maximum permissible load for the load hook.
Risk of tipping over
In the event of an overload, a warning is issued in the form
of a visual display and acoustic signal. This does not
prevent the risk of tipping over.
Danger of serious injury and death.
Z Do not overload the machine.
Z Operate the machine with due care.
To Next Page
Loading...
