B95W
Operation
07_Bedienung_en.fm - V1.0 - 1.8.17
213 / 306
7
26
7.2 Starting and switching off the engine
Starting the engine
Set all control levers to the neutral position.
Engage the parking brake.
Place the lever for the travel direction preselection in the neutral position.
Insert the ignition key into the preheating/start switch.
Turn the ignition key clockwise to position “1”.
J The control light “Charge indicator” lights up.
When the main view appears on the display, turn the ignition key to position “2”.
Release the ignition key as soon as the engine is running smoothly.
J The ignition key turns back to position “1”.
J The control light “Charge indicator” goes off.
If the engine does not start after max. 30 seconds, return the ignition key to
position “1” or “0”. Repeat the starting procedure after 1 minute at the earliest.
If the engine fails to fire after 2 starting attempts, there is a fault.
Danger due to heavy load
Machine may move unexpectedly.
Danger of serious injuries with fatal consequences.
Z Before starting the engine , take care to ensure that no one
is in the immediate vicinity of the machine or in the danger
zone.
Risk posed by insufficient lubrication
Insufficient lubrication may result in damage to the engine.
Z Do not drive the engine at full throttle straightaway.
Z Drive with restraint until the engine reaches operating
temperature.
Notice
Each time before putting the machine into operation, the inspections
according to section 7.8 must be carried out.
Notice
Fault causes and their resolution: See chapter 10.3 “Troubleshooting and
fault rectification”, consult your Yanmar dealer if necessary.
To Next Page
Loading...
Need help?
General
