Yanmar B95W - While out of Service; At the End of the Period of Non-Usage

B95W
Maintenance
202 / 306
6
06_Wartung und Pflege_en.fm - V1.0 - 1.8.17
20
 Check the antifreeze properties of the coolant and adapt these, if necessary.
 Apply all preservation measures as specified in the operating instructions for
the engine.
 Protect tires from direct sunlight.
 Treat bare piston rods with a commercially available corrosion protection agent.
 Remove the battery, clean it, and store it properly in a dry and, over winter,
in a frost-free room. Cover the poles with pole grease.
 Close the air intake openings of the air filter system and the exhaust outlet on
the exhaust pipe.
 Switch off the battery isolator switch.
6.8.2 While out of service
Movements
 The anti-corrosion coat must be cleaned from the piston rods, and the openings
of the air filter system and the exhaust pipe freed.
 Once the machine has been out of use for six months, all assemblies must be
brought to operating temperature and set in motion for approx. 15 minutes.
 Renew the preservation measures after performing these movements.
6.8.3 At the end of the period of non-usage
Before recommissioning the machine, the following measures must be carried out:
Putting the machine back into service
 Clean the piston rods to remove the corrosion protection coating.
 Clear the air intake of the air filter and the exhaust opening.
 Check the condition of main air filter cartridge and safety cartridge, replace if
necessary.
 Wash the machine with a neutral detergent.
 Check the battery, recharge if necessary and install it.
 Carry out all measures for putting the diesel engine back into service as
detailed in the engine operating instructions.
 If the machine has been out of use for more than 6 months, the oil in
assemblies such as the engine, transmission, etc. must be changed.
 As soon as the machine has been out of action for six months (if not before),
replace the hydraulic filters (pressure, return, and ventilation filter, if applicable).
 Lubricate the machine in accordance with the lubrication schedule.
J See chapter 6.5.1 “Lubrication schedule”.