B95W
Safety
03_Sicherheit_en.fm - V 0.1 - 1.8.17
39 / 306
3
46
3.19 Interruptions in work
Before rest periods and the end of work, park the machine on a level base
with sufficient load bearing capacity and secure it reliably to prevent
unintentional movement.
Put the machine into the parking position. Uppercarriage in the driving position.
Before rest periods and the end of work, lower the working attachment to the
ground to prevent it from moving.
Do not leave the machine before you have lowered and secured the work
equipment.
Machines are only to be parked in places where they do not obstruct, e.g., public
or construction site traffic. Warning devices, e.g., warning triangles, warning
cordons, flashing or hazard lights are to be used if necessary.
Before leaving the operator's stand, return all control elements to the neutral
position, apply the brakes and switch off the working hydraulics.
Before exiting the machine, shut down the engine and secure it against
unauthorized restarting (e.g., by pulling out the ignition key or disconnecting
the battery if necessary). Disconnect the machine’s power supply by flicking
the battery isolator.
For longer periods of work stoppage:
• Relieve the residual pressures.
• Switch off the battery isolator switch.
Secure the machine against rolling away.
3.20 Hoisting operation
Hoisting involves the lifting, transporting, and lowering of loads with the aid of
sling gear (rope, chain, etc.), whereby personnel are needed to assist with
attaching and releasing the load. Such work covers, e.g., the lifting and lowering
of pipes, tubbing rings or containers using earth-moving machines.
Earth-moving machines are only to be used for hoisting when the prescribed
safety devices are present and in full working order. For earth-moving machines,
these are:
• Secure attachment of a load-bearing medium
• Carrying capacity table
• Overload warning device
• Line break safeguard on boom cylinder and dipper stick cylinder
To Next Page
Loading...
