B95W
Troubleshooting
292 / 306
10
10_Fehlerbeseitigung_en.fm - V1.0 - 1.8.17
30
10.1 Who is allowed to rectify malfunctions?
• During the warranty period, malfunctions must be dealt with by your responsible
service agent or a specialist workshop.
• If a problem can only be eliminated through repair, then your responsible
service agent must be called in.
• Only service staff may carry out troubleshooting. Maintain sufficient distance
from rotating parts.
Engine
malfunctions
• All defects and faults in the engine must be examined as described in the
separate engine operating instructions. During the warranty period, malfunctions
must be dealt with by the responsible service agent or a specialist workshop.
• When carrying out repairs in the engine compartment, ensure that the engine
is cold.
10.2 Before troubleshooting and fault rectification
îš‹ Park the machine on a solid and level base.
îš‹ Put the machine into the parking position.
îš‹ The machine is only to be parked in places where it does not cause an
obstruction, e.g., for public or construction site traffic.
îš‹ Lower the loading equipment to the ground by supporting it on the dipper, by
deposing it on the ground or similar.
îš‹ Lower the dozer blade.
îš‹ Lower work tool. Relieve any residual pressures.
îš‹ Shut down the engine and pull out the ignition key.
 Disconnect the machine’s power supply by flicking the battery isolator.
îš‹ Put the exit barrier (left-hand armrest) in the upright position.
îš‹ Lock the windows and the doors.
îš‹ Secure the machine with wheel chocks to prevent it from rolling.
îš‹ When stepping up into or out of the vehicle, use the designated steps and
surfaces or suitable aids (such as ladders or platforms). At least three of the
machine’s supports must be in place whenever entering or exiting the vehicle.
îš‹ Take great care when troubleshooting.
To Next Page
Loading...
Need help?
General
