B95W
Maintenance
06_Wartung und Pflege_en.fm - V1.0 - 1.8.17
185 / 306
6
20
A = Front axle
B = Rear axle except for B95W
AL
C = Rear axle B95W AL
Allow the engine to run at medium speed.
Step halfway down on the brake pedal (4).
Open the bleeding screws (2) on the two brake housings of the front axle, one
after the other, until the braking medium (hydraulic oil) emerges bubble-free.
Tighten the bleed screws.
Open the bleeding screws on the two brake housings of the rear axle one
after the other until the braking medium (hydraulic oil) emerges bubble-free.
Tighten the bleed screws.
Remove the bleed screw on the brake inching (hydraulic pump for travel) until
the braking medium (hydraulic oil) escapes without bubbles.
Tighten the bleed screw.
Notice
This work must be carried out by two people.
Danger posed by environmentally hazardous
substances
Waste oil can be discharged into the environment and
cause considerable environmental damage.
Z Do not allow waste oil to seep into the ground.
Z Always place a receptacle for the collection of waste oil
under the working area (when draining oil or removing the
filter element).
Z Collect the waste oil and dispose of it according to
regulations!
To Next Page
Loading...
