6-86
Related Parameters
Parameter
Number
Name
Description
Setting
Range
Factory
Setting
Change
during
Operation
Control Methods
Display
V/f
V/f
with
PG
Open
Loop
Vector
1
Flux
Vector
Open
Loop
Vector
2
b1-01
Frequency
Reference
Selection
Selects the frequency reference
input source.
0: Operator - Digital preset speed
U1-01 or d1-01 to d1-17.
1: Terminals - Analog input
terminal A1 (or terminal A2
based on parameter H3-09).
2: Serial Com - Modbus RS-422/
485 terminals R+, R-,
S+, and S-.
3: Option PCB - Option board
connected on 2CN.
4: Pulse Input (Terminal RP)
0 to 4 1 No QQQQQ
Reference
Source
b1-02
Run
Command
Selection
Selects the run command input
source.
0: Operator - RUN and STOP
keys on Digital Operator.
1: Terminals - Contact closure on
terminals S1 or S2.
2: Serial Com - Modbus RS-422/
485 terminals R+, R-,
S+, and S-.
3: Option PCB - Option board
connected on 2CN.
0 to 3 1 No QQQQQ
Run Source
H5-01
Drive Node
Address
Selects Drive station node number
(address) for Modbus terminals
R+, R-, S+, S-. The Drive's power
must be cycled for the setting to
take effect.
0 to 20
*
1F No AAAAA
Serial Comm
Adr
H5-02
Communicati
on Speed
Selection
Selects the baud rate for Modbus
terminals R+, R-, S+ and S-. The
Drive's power must be cycled for
the setting to take effect.
0: 1200 bps
1: 2400 bps
2: 4800 bps
3: 9600 bps
4: 19200 bps
0 to 4 3 No AAAAA
Serial Baud
Rate
H5-03
Communicati
on Parity
Selection
Selects the communication parity
for Modbus terminals R+, R-, S+
and S-. The Drive's power must be
cycled for the setting to take
effect.
0: No Parity
1: Even Parity
2: Odd Parity
0 to 2 0 No AAAAA
Serial Com
Sel
H5-04
Stopping
Method After
Communicati
on Error
Selects the stopping method when
a communication timeout fault
(CE) is detected.
0: Ramp to Stop
1: Coast to Stop
2: Fast-Stop
3: Alarm Only
0 to 3 3 No AAAAA
Serial Fault
Sel
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
