6-146
During the copy operation, errors may occur. If an error is displayed, press any key to cancel the error display
and return to the 03-01 display.
Error displays and their meanings are shown below. (Refer to Chapter 7 Errors when Using Digital Operator
Copy Function.)
5 Change the set value to 2 using the Increment Key.
6 Set the changed data using the DATA/ENTER Key. The COPY function will start.
7 If the COPY function ends normally, End is displayed on the Digital Operator.
8 The display returns to o3-01 when a key is pressed.
Error Display Meaning
Drive product code and Drive software number are different.
Drive capacity with which you are trying to copy, and the Drive capacity stored in the
Digital Operator are different.
The Drive control method in which you are trying to copy, and the Drive control method
stored in the Digital Operator are different.
Comparison between the parameter written to the Drive and the parameter in the Digital
Operator shows they are different.
After copying has ended, comparison between the sum value of the Drive parameter area
and the sum value of the Digital Operator parameter area shows they are different.
Table 6.2 COPY Function Procedure
Step
No.
Digital Operator Display Explanation
Copy Funtion Sel
-ADV-
o3-01= 2
OP→INV WRITE
*0*
Copy Funtion Sel
-ADV-
o3 - 01=0
COPY SELECT
*0*
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
