Parameter Details
2
2.8 H: Terminal Functions
YASKAWA TOEPYAIGA8002B GA800 Drive Programming 395
■ E: Fault
Setting Value Function Description
E Fault
The terminal activates when the drive detects a fault.
Note:
The terminal will not activate for CPF00 and CPF01 [Control Circuit Error] faults.
■ F: Not Used
Setting Value Function Description
F Not Used
Use this setting for unused terminals or to use terminals in through mode. Also use this setting as the PLC contact output via
MEMOBUS/Modbus or the communication option. This signal does not function if signals from the PLC are not configured.
■ 10: Alarm
Setting Value Function Description
10 Alarm
The terminal turns on when the drive detects a minor fault.
■ 11: Fault Reset Command Active
Setting Value Function Description
11 Fault Reset Command
Active
The terminal turns on when the drive receives the Reset command from the control circuit terminal, serial communications, or the
communication option.
■ 12: Timer Output
Setting Value Function Description
12 Timer Output
Use this setting when the drive uses the timer function as an output terminal.
Note:
Refer to “b4: Timer Function” for more information.
■ 13: Speed Agree 2
Setting Value Function Description
13 Speed Agree 2
The terminal activates when the output frequency is in the range of the frequency reference ± L4-04 [Speed Agree Detection Width
(+/-)].
Note:
• The detection function operates in the two motor rotation directions.
• The drive outputs the motor speed status when A1-02 = 3, 7 [Control Method Selection = CLV, CLV/PM].
ON : The output frequency is in the range of “frequency reference ± L4-04”.
OFF : The output frequency is not in the range of “frequency reference ± L4-04”.
To Next Page
Loading...
