3.14 24 V Control Power Supply Unit Wiring
126 YASKAWA ELECTRIC SIEP C710636 02B YASKAWA U1000 Technical Manual
■ Wire Gauges and Tightening Torques
Table 3.29 Wire Gauges and Tightening Torques
■ Ferrule-Type Wire Terminations
Crimp a ferrule to signal wiring to improve wiring simplicity and reliability. Use CRIMPFOX6, a crimping tool
manufactured by PHOENIX CONTACT.
Figure 3. 81
Figure 3.80 Ferrule Dimensions
Table 3.30 Ferrule Terminal Types and Sizes
■ Power Supply and the Control Circuit
Tabl e 3.31 outlines the various conditions under which the option provides power to the control circuit.
Table 3.31 Power Supply and Control Circuit
■ UL and CE Compliance
External Power Supply
Use a Class 2 power supply as defined by UL standards for the customer-supplied power supply connection to the 24 V
Control Power Supply Unit.
◆ 24 V Control Power Supply Unit Specifications
Table 3.32 24 V Control Power Supply Unit Specifications
Terminal
Number
Screw
Size
Tightening
Torque
Nm
(inlb)
Bare Cable Crimp Terminals
Wire Type
Recomm. Gauges
mm
2
(AWG)
Applicable Gauges
mm
2
(AWG)
Recomm. Gauges
mm
2
(AWG)
Applicable Gauges
mm
2
(AWG)
24, 0, FE M2
0.22 to 0.25
(1.95 to 2.21)
0.75
(18 AWG)
Standard wire:
0.25 to 1.0
(24 to 17 AWG)
Single line:
0.25 to 1.5
(24 to 16 AWG)
0.5
(20 AWG)
0.25 to 0.5
(24 to 20 AWG)
Shielded cable, etc.
Size mm
2
(AWG) Type L (mm) d1 (mm) d2 (mm) Manufacturer
0.25 (24)
AI 0.25-6YE
AI 0.25-6BU
10.5 0.8 2.0
PHOENIX CONTACT
0.34 (22) AI 0.34-6TQ 10.5 0.8 2.0
0.5 (20) AI 0.5-6WH 12 1.1 2.5
Drive Main Circuit Input Power Supply Power from 24 V Control Power Supply Unit Control Circuit Operation in Drive Drive Operation
ON ON
Operating
Possible
ON OFF Possible
OFF ON Not possible
OFF OFF Stopping Not possible
Item
<1> Use a Class 2 power supply with a capacity of 24 V to comply with UL standards.
Specifications
Input Operating Voltage 24 Vdc ± 20% (19.2 V to 28.8 V)
Input Current 1.9 A
Consumption Power 38 W
Compliance UL
<1>
, CE
d1
d2
6 mm
L
SIEP_C710636_02B_1_0.book 126 ページ 2015年11月25日 水曜日 午後4時56分