YASKAWA U1000 Series - Terminal Cover

84 YASKAWA ELECTRIC SIEP C710636 02B YASKAWA U1000 Technical Manual
3.5 Terminal Cover
3.5 Terminal Cover
Follow the procedure below to remove the terminal cover for wiring and to reattach the terminal cover after wiring is
complete.
◆ 20028 to 20130, 40011 to 40124
■ Removing the Terminal Cover
1. Loosen the terminal cover screw.
Figure 3. 16
Figure 3.15 Removing the Terminal Cover
2. Push in on the hook located on the bottom of the terminal cover, and gently pull forward. This should remove the
terminal cover.
Figure 3. 17
Figure 3.16 Removing the Terminal Cover
■ Reattaching the Terminal Cover
Power lines and signal wiring should pass through the opening provided. Refer to Wiring the Main Circuit Terminal on
page 98 and Wiring the Control Circuit Terminal on page 106 for details on wiring.
Reattach the terminal cover after completing the wiring to the drive and other devices.
Figure 3. 18
Figure 3.17 Reattaching the Terminal Cover
<1> Connect the ground wiring first, then the main circuit wiring, and finally the control circuit wiring.
<1>
SIEP_C710636_02B_1_0.book 84 ページ ２０１５年１１月２５日 水曜日 午後４時５６分