5.11 U: Monitor Parameters
YASKAWA ELECTRIC
SIEP C710636 02B YASKAWA U1000 Technical Manual 339
◆ U6: Control Monitors
Control monitors show:
• Reference data for the output voltage and vector control
• Data on PM motor rotor synchronization, forward phase compensation, and flux positioning
• Pulse data from the PG motor encoder
• Pulse data for Zero Servo control
• ASR and Feed Forward control monitors
Refer to Figure 5.36 on page 222 and Figure 5.37 on page 222 for details and an illustration showing where monitors
are located in the ASR block.
• The offset value added to the frequency reference by the frequency offset function. Refer to Setting 44, 45, 46: Offset
frequency 1, 2, 3 on page 273.
• The bias value added to the frequency reference by the Up/Down 2 function (refer to Setting 75, 76: Up 2, Down 2
command on page 274)
Refer to U6: Control Monitors on page 529 for a complete list of U6- monitors and descriptions.
◆ U8: DriveWorksEZ Monitors
These monitors are reserved for use with DriveWorksEZ.
A complete description of the U8- monitors can be found in the DriveWorksEZ instruction manual.
◆ U9: Power Monitors
The total consumed power and regenerated power are displayed for these parameters.
Refer to U9: Power Monitors on page 531 for a complete list of U9- monitors and descriptions.
SIEP_C710636_02B_1_0.book 339 ページ ２０１５年１１月２５日 水曜日 午後４時５６分
To Next Page
Loading...
