YASKAWA U1000 Series - CONNECTING PERIPHERAL DEVICES

436 YASKAWA ELECTRIC SIEP C710636 02B YASKAWA U1000 Technical Manual
8.3 Connecting Peripheral Devices
8.3 Connecting Peripheral Devices
Figure 8.1 and Figure 8.2 illustrate how to configure the drive and motor to operate with various peripheral devices.
For more detailed instructions on how to install each device shown below, refer to the specific manual for that device.
Note: Note that if the drive is set to trigger a fault output whenever the fault restart function is activated (L5-02 = 1), then a sequence to
interrupt power when a fault occurs will result in shutting off the power to the drive as the drive attempts to restart itself. The
default setting for L5-02 is 0 (fault output active during restart attempt).
◆ CIMR-U20028 to 20248, CIMR-U40011 to 40590
Figure 8. 1
Figure 8.1 Connecting Peripheral Devices (CIMR-U20028)
Cop
y
V
er
if
y
R
ead
LOCK
YASKAWA
JVOP-181
USB Copy Unit
COM ERR
Power
Supply
Surge
Absorber
LED Operator/LCD Operator
Engineering Software Tools
USB
Copy unit
Ground
Ground
Motor
Magnetic
Contactor
(switches to
line power)
USB Cable
(Type-AB)
USB Cable
(Type-AB, sold separately)
PC
Momentary
Power Loss
Recovery Unit
Line
Breaker
(MCCB)
or
Leakage
Breaker
Magnetic
Contactor
(MC)
Zero-phase
Reactor
U1000
U/T1 V/T2 W/T3 R/L1 n1p1
N B1/P
S/L2 T/L3
DriveWizard
DriveWorksEZ
SIEP_C710636_02B_1_0.book 436 ページ ２０１５年１１月２５日 水曜日 午後４時５６分