YASKAWA U1000 Series - Remote Operation

2.2 Mechanical Installation
Mechanical Installation
2
YASKAWA ELECTRIC SIEP C710636 02B YASKAWA U1000 Technical Manual 55
◆ Digital Operator Remote Usage
■ Remote Operation
The digital operator mounted on the drive can be removed and connected to the drive using a remote control extension
cable up to 3 m long. This makes it easier to operate the drive when it is installed in a location where it can not be
accessed easily.
The digital operator can also be permanently mounted in a remote location like a panel door. A remote control extension
cable and an installation support set (depending on the installation type) will be required.
Note: Refer to Drive Options and Peripheral Devices on page 433 for information on remote control extension cables and installation
support sets.
Figure 2.11
Figure 2.11 Communication Cable Connection
■ Digital Operator Remote Installation
Digital Operator Dimensions
Figure 2.12 Digital Operator Dimensions
S / N : J007XE273710001
OperatorDrive
Communication Cable Connector
Comm Port
S / N : J007XE273710001
90
78
60
7.9
minimum
50
Unit: mm
12.2
1.6
Installation holes (2-M3 screws, depth 5)
44
15
SIEP_C710636_02B_1_0.book 55 ページ ２０１５年１１月２５日 水曜日 午後４時５６分