YASKAWA U1000 Series - Page 54

2.2 Mechanical Installation
54 YASKAWA ELECTRIC SIEP C710636 02B YASKAWA U1000 Technical Manual
2. Pass wire through the holes of all four hanging brackets.
Figure 2. 8
Figure 2.8 Drive Suspension Using Wires and Hanging Brackets (20154 to 20248, 40156 to 40414)
3. Gradually take up the slack in the wires and hoist the drive after the wires are stretched tight.
4. Lower the drive when ready to install in the enclosure panel. Stop lowering the drive when it is near the floor,
then slowly begin lowering the drive again very slowly until the drive is placed correctly.
40477 to 40930
1. Pass wire through the holes of all four hanging brackets.
Figure 2. 9
Figure 2.9 Drive Suspension Using Wires and Hanging Brackets (40477 to 40930)
2. Gradually take up the slack in the wires and hoist the drive after the wires are stretched tight.
3. Lower the drive when ready to install in the enclosure panel. Stop lowering the drive when it is near the floor,
then slowly begin lowering the drive again very slowly until the drive is placed correctly.
Harmonic Filter Module
1. Pass wire through the holes of all four hanging brackets.
Figure 2. 10
Figure 2.10 Harmonic Filter Module Suspension Using Wires and Hanging Brackets (EUJ7118.)
2. Gradually take up the slack in the wires and hoist the harmonic filter module after the wires are stretched tight.
3. Lower the harmonic filter module when ready to install in the enclosure panel. Stop lowering the harmonic filter
module when it is near the floor, then slowly begin lowering the harmonic filter module again very slowly until the
harmonic filter module is placed correctly.
Suspending angle:
50
° or greater
Suspending angle:
50° or greater
Suspending angle:
50° or greater
SIEP_C710636_02B_1_0.book 54 ページ ２０１５年１１月２５日 水曜日 午後４時５６分