YASKAWA U1000 Series - A: INITIALIZATION

176 YASKAWA ELECTRIC SIEP C710636 02B YASKAWA U1000 Technical Manual
5.1 A: Initialization
5.1 A: Initialization
The initialization group contains parameters associated with initial setup of the drive. Parameters involving the display
language, access levels, initialization, and password are located in this group.
◆ A1: Initialization
■ A1-00: Language Selection
Selects the display language for the digital operator.
Note: This parameter is not reset when the drive is initialized using parameter A1-03.
Setting 0: English
Setting 1: Japanese
Setting 2: German
Setting 3: French
Setting 4: Italian
Setting 5: Spanish
Setting 6: Portuguese
Setting 7: Chinese
■ A1-01: Access Level Selection
Allows or restricts access to drive parameters.
Setting 0: Operation only
A1-01, A1-04, and Drive Mode can be accessed and set. All U monitor parameters can be accessed. Parameters that are
set in A2-01 to A2-32 can be accessed in Setup Mode. Verify Mode, Setup Mode, and Auto-Tuning Mode cannot be
accessed.
Setting 1: User Parameters
A1-00, A1-01, A1-04, and Drive Mode can be accessed and set. All U monitor parameters can be accessed.
Parameters that are set in A2-01 through A2-32 can be accessed in Setup Mode. Verify Mode and Auto-Tuning Mode
cannot be accessed.
Setting 2: Advanced Access Level (A) and Setup Access Level (S)
All parameters can be viewed and edited.
Notes on Parameter Access
• If the drive parameters are password protected by A1-04 and A1-05, parameters A1-01 through A1-03, A1-06, A1-07,
and A2-01 through A2-32 cannot be modified.
• If a digital input terminal programmed for “Program lockout” (H1- = 1B) is enabled, parameter values cannot be
modified, even if A1-01 is set to 1 or 2.
• If parameters are changed via serial communication, then it will not be possible to edit or change parameters settings
with the drive’s digital operator until an Enter command is issued to the drive from the serial communication.
No.
<1> Regional default settings
Setting 0: Asia (Model code: CIMR-UT) and India (Model code: CIMR-UD)
Setting 1: Japan (Model code: CIMR-UA)
Setting 7: China (Model code: CIMR-UB)
Parameter Name Setting Range Default
A1-00 Language Selection 0 to 7 <1>
No. Parameter Name Setting Range Default
A1-01 Access Level Selection 0 to 2 2
SIEP_C710636_02B_1_0.book 176 ページ ２０１５年１１月２５日 水曜日 午後４時５６分