YASKAWA U1000 Series - To 20248, 40156 to 40930

3.5 Terminal Cover
Electrical Installation
3
YASKAWA ELECTRIC SIEP C710636 02B YASKAWA U1000 Technical Manual 85
◆ 20154 to 20248, 40156 to 40930
■ Removing the Terminal Cover
1. Loosen the screws on the terminal cover, then pull down on the cover.
CAUTION! Crush Hazard. Do not completely remove the cover screws, just loosen them. If the cover screws are removed completely,
the terminal cover may fall off causing an injury. Take special care when removing/reattaching the terminal covers for larger drives.
Figure 3.19
Figure 3.18 Removing the Terminal Cover
2. Pull forward on the terminal cover to free it from the drive.
Figure 3.20
Figure 3.19 Removing the Terminal Cover
■ Reattaching the Terminal Cover
Once wiring to the terminal board and other devices is complete, double check all connections and finally reattach the
terminal cover. Refer to Wiring the Main Circuit Terminal on page 98 and Wiring the Control Circuit Terminal on
page 106 for details on wiring.
Figure 3.21
Figure 3.20 Reattaching the Terminal Cover
<1> Connect the ground wiring first, then the main circuit wiring, and finally the control circuit wiring.
<1>
SIEP_C710636_02B_1_0.book 85 ページ ２０１５年１１月２５日 水曜日 午後４時５６分