588 YASKAWA ELECTRIC SIEP C710636 02B YASKAWA U1000 Technical Manual
D.2 European Standards
D.2 European Standards
Figure D.1
Figure D.1 CE Mark
The CE mark indicates that a product is in compliance with applicable European Directives for safety and environmental
regulations. It is required for engaging in business and commerce in Europe.
The applicable European Directives for this product are as follows. We declared the CE marking based on the
harmonized standards in the following table.
The user(s) is solely responsible for ensuring that the end products used with this drive comply with all applicable
European directives and with other national regulations (if required).
◆ CE Low Voltage Directive Compliance
This drive has been tested according to European standard IEC/EN 61800-5-1, and it fully complies with the Low
Voltage Directive.
To comply with the Low Voltage Directive, be sure to meet the following conditions when combining this drive with
other devices:
■
Area of Use
Do not use drives in areas with pollution higher than degree 2 and overvoltage category 3 in accordance with
IEC/EN 664.
■
Grounding
The drive is designed to be used in T-N (grounded neutral point) networks. If installing the drive in other types of
grounded systems, contact your Yaskawa representative for instructions. Refer to Enable the Internal EMC Filter on
page 119 for details.
■
Guarding Against Harmful Materials
When installing IP00 enclosure drives, use an enclosure that prevents foreign material from entering the drive from
above or below.
Applicable European Directive Applicable Harmonized Standards
Low Voltage Directive (2006/95/EC) IEC/EN 61800-5-1: 2007
EMC Guidelines (2004/108/EC)
EN 61800-3: 2004/A1: 2012
IEC 61800-3: 2004/A1: 2011
Machinery Directive (2006/42/EC)
EN ISO 13849-1/AC:2008 (PL e (Cat.3))
IEC 62061/A1:2012 (SIL CL 3)
EN 62061/A1:2013 (SIL CL 3)
IEC/EN 61800-5-2:2007 (SIL3)
SIEP_C710636_02B_1_0.book 588 ページ ２０１５年１１月２５日 水曜日 午後４時５６分
To Next Page
Loading...
