YASKAWA U1000 Series - Digital Operator and

86 YASKAWA ELECTRIC SIEP C710636 02B YASKAWA U1000 Technical Manual
3.6 Digital Operator and Front Cover
3.6 Digital Operator and Front Cover
Detach the digital operator from the drive for remote operation or when opening the front cover to install an option card.
NOTICE: Be sure to remove the digital operator prior to opening or reattaching the front cover. Leaving the digital operator plugged
into the drive when removing the front cover can result in erroneous operation caused by a poor connection. Firmly fasten the front
cover back into place before reattaching the digital operator.
◆ Removing/Reattaching the Digital Operator
■ Removing the Digital Operator
While pressing on the tab located on the right side of the digital operator, pull the digital operator forward to remove it
from the drive.
Figure 3. 22
Figure 3.21 Removing the Digital Operator
■ Reattaching the Digital Operator
Insert the digital operator into the opening in the front cover while aligning it with the notches on the left side of the
opening. Next, press gently on the right side of the operator until it clicks into place.
Figure 3. 23
Figure 3.22 Reattaching the Digital Operator
◆ Removing/Reattaching the Front Cover
■ Removing the Front Cover
20028 to 20130, 40011 to 40124
After removing the terminal cover and the digital operator, loosen the screw that affixes the front cover. Pinch in on the
tabs found on each side of the front cover, then pull forward to remove it from the drive.
Figure 3. 24
Figure 3.23 Remove the Front Cover (20028 to 20130, 40011 to 40124)
SIEP_C710636_02B_1_0.book 86 ページ ２０１５年１１月２５日 水曜日 午後４時５６分