i.2 General Safety
YASKAWA ELECTRIC
SIEP C710636 02B YASKAWA U1000 Technical Manual 27
◆ Drive Label Warnings
Always heed the warning information listed in Figure i.2 in the position shown in Figure i.3.
Figure i.2
Figure i.2 Warning Information
Figure i.3
Figure i.3 Warning Information Position
◆ Warranty Information
■ Warranty Period
This drive is warranted for 12 months from the date of delivery to the customer or 18 months from the date of shipment
from the Yaskawa factory, whichever comes first.
■
Scope of Warranty
Inspections
Customers are responsible for periodic inspections of the drive. Upon request, a Yaskawa representative will inspect the
drive for a fee. If the Yaskawa representative finds the drive to be defective due to Yaskawa workmanship or materials
and the defect occurs during the warranty period, this inspection fee will be waived and the problem remedied free of
charge.
Repairs
If a Yaskawa product is found to be defective due to Yaskawa workmanship or materials and the defect occurs during the
warranty period, Yaskawa will provide a replacement, repair the defective product, and provide shipping to and from the
site free of charge.
However, if the Yaskawa Authorized Service Center determines that the problem with the drive is not due to defective
workmanship or materials, the customer will be responsible for the cost of any necessary repairs. Some problems that are
outside the scope of this warranty are:
WARNING
Read manual before installing.
Wait 5 minutes for capacitor
discharge after disconnecting
power supply.
To conform to rrequirements,
make sure to ground the supply
neutral for 400V class.
After disconnecting from power
supply,please wait 5 minutes
before inspecting, performing
maintenance or wiring the
drive.
Risk of electric shock.
Hot Surfaces
Wait 5 minutes or longer
until the unit has cooled.
●
●
●
●
●
SIEP_C710636_02B_1_0.book 27 ページ ２０１５年１１月２５日 水曜日 午後４時５６分
To Next Page
Loading...
