5.1 A: Initialization
180 YASKAWA ELECTRIC SIEP C710636 02B YASKAWA U1000 Technical Manual
Note: Parameter settings can be edited after entering the correct password. Performing a 2-wire or 3-wire initialization resets the
password to “0000”. Reenter the password to parameter A1-05 after drive initialization.
■ A1-06: Application Preset
Several Application Presets are available to facilitate drive setup for commonly used applications. Selecting one of these
Application Presets automatically programs certain parameters to a new set default values and selects the functions for
the I/O terminals that best suit the application. All parameters changed when selecting an Application Preset are also
assigned to the list of User Parameters, A2-01 through A2-16. These can be edited more easily in the Setup Mode and
provide quicker access by eliminating the need to scroll through multiple menus.
Refer to Application Selection on page 148 for details on parameter A1-06.
3.
Press to scroll to A1-04.
4.
Press the key.
Use , , , and to enter the password.
5.
Press to save the new password.
6. Drive returns to the parameter display.
7.
Press and scroll to A1-02.
8.
Press to display the value set to A1-02.
9.
Use or to change the value if desired (though changing the control mode at this point is not typically done).
10.
Press to save the setting, or press to return to the previous display without saving changes.
11. The display automatically returns to the parameter display.
Step Display/Result
←→
-PRMSET-
A1- 04 = 0
(0~9999)
“0”
PRG
Enter Password
FWD
←→
-PRMSET-
A1- 04 = 1234
(0~9999)
“0”
PRG
Enter Password
FWD
←→
-PRMSET-
A1- 04 = 0
(0~9999)
“0”
PRG
Enter Password
FWD
←→
-PRMSET- PRG
Control Method
FWD
A1-02= 2
∗2∗
Open Loop Vector
“2”
←→
-PRMSET- PRG
Control Method
FWD
A1-02= 2
∗2∗
Open Loop Vector
←→
-PRMSET-
V/F Control
“2”
PRG
Control Method
FWD
A1-02= 0
∗2∗
←→
-PRMSET-
V/F Control
PRG
Control Method
FWD
A1-02= 0
∗0∗
SIEP_C710636_02B_1_0.book 180 ページ ２０１５年１１月２５日 水曜日 午後４時５６分
To Next Page
Loading...
