Yealink SIP-T56A - Page 61

Getting Started
61
6. Tap the Security field.
7. Tap the desired value.
- If you select WEP or WPA/WPA2 PSK:
1) Enter the password in the Password field.
- If you select 802.1x EAP:
1) Tap the EAP method field.
2) Tap the desired EAP method in the pop-up dialog box.
- If you select PEAP/TTLS:
a) Tap the Phase-2 authentication field.
b) Tap the desired Phase-2 authentication method in the pop-up dialog
box.
c) Enter the identity (username) in the Identity field.
d) Enter the anonymous identity (username) in the Anonymous identity
field (to be used as the unencrypted identity).
e) Enter the password in the Password field.
- If you select TLS:
a) Enter the username in the Identity field
- If you select PWD:
a) Enter the username in the Identity field.
b) Enter the password in the Password field.
8. You can do the following:
- Tap the Show password radio box to make the password visible.
- Tap the Show advanced options radio box to configure the HTTP proxy for Browser
application. For more information, refer to Browser on page 227.
9. Tap Save to accept the change.