Yealink SIP VP-T49G

User Guide for SIP VP-T49G IP Phone
232
You can do the following actions:
- Tap the DPickup soft key to pick up the call.
- Tap the Send soft key to dial out the monitored phone number.
- Tap the NewCall soft key to place a new call.
- Tap the Cancel soft key to exit the screen.
Note
Configuring Transfer Mode on DSS Key
When there is an active call on the IP phone, you can handle the active call differently
depending on the configuration of the transfer mode via Dsskey with the BLF key.
To configure the transfer mode on DSS key via web user interface:
1. Click on Features->Transfer.
2. Select the desired transfer mode from the pull-down list of Transfer Mode via Dsskey.
 If you select Blind Transfer, tap the BLF key to blind transfer the call to the monitored
user.
 If you select Attended Transfer, tap the BLF key to dial out the monitored phone
number and then perform an attended or a semi-attended transfer.
 If you select New Call, tap the BLF key to place a new call to the monitored user.
The original call is placed on hold.
3. Click Confirm to accept the change.
Configuring Directed Call Pickup Code
If you configure the directed call pickup code in advance, you can pick up the monitored user’s
incoming call by tapping the BLF key. You can configure the directed call pickup code when
configuring a BLF key. For more information, refer to Configuring a BLF Key on page 229. You
can also configure the directed call pickup code on a global or per-line basis via web user
If your phone is locked, you cannot use the DPickup, Send, NewCall and Cancel soft keys until
unlocked. For more information refer to Phone Lock on page 79.