Yealink Teams Series

| Phone Network | 15
Phone UI
> Settings > Device Settings > Network(Admin only, default password:
admin) > WAN Port > IPv6 Type(Static IP) > Default Gateway
Parameter static.network.ipv6_primary_dns
[1]
<MAC>.cfg
Description
It configures the primary IPv6 DNS server.
Example:
static.network.ipv6_primary_dns = 3036:1:1:c3c7:c11c:5447:23a6:256
Note: It works only if “static.network.ip_address_mode" is set to 1 (IPv6)
or 2 (IPv4 & IPv6). In DHCP environment, you also need to make sure
“static.network.ipv6_static_dns_enable" is set to 1 (On).
Permitted Values Primary IPv6 DNS server address
Default Blank
Web UI Network > Basic > IPv6 Config > Configuration Type(Static IP) > Primary DNS
Or Network > Basic > IPv6 Config > Configuration Type(DHCP) > Static
DNS(Enable) > Primary DNS
Phone UI
> Settings > Device Settings > Network(Admin only, default password:
admin) > WAN Port > IPv6 Type(Static IP) > Pri.DNS
Or > Settings > Device Settings > Network(Admin only, default password:
admin) > WAN Port > IPv6 Type(DHCP) > IPv6 Static DNS(Enable) > Pri.DNS
Parameter static.network.ipv6_primary_dns
[1]
<MAC>.cfg
Description
It configures the secondary IPv6 DNS server.
Example:
static.network.ipv6_secondary_dns = 2026:1234:1:1:c3c7:c11c:5447:23a6
Note: It works only if “static.network.ip_address_mode" is set to 1 (IPv6)
or 2 (IPv4 & IPv6). In DHCP environment, you also need to make sure
“static.network.ipv6_static_dns_enable" is set to 1 (On).
Permitted Values Secondary IPv6 DNS server address
Default Blank
Web UI Network > Basic > IPv6 Config > Configuration Type(Static IP) > Secondary DNS
Or Network > Basic > IPv6 Config > Configuration Type(DHCP) > Static
DNS(Enable) > Secondary DNS
Phone UI
> Settings > Device Settings > Network(Admin only, default password:
admin) > WAN Port > IPv6 Type(Static IP) > Sec.DNS
Or > Settings > Device Settings > Network(Admin only, default password:
admin) > WAN Port > IPv6 Type(DHCP) > IPv6 Static DNS(Enable) > Sec.DNS
Parameter static.network.ipv6_icmp_v6.enable
[1]
<MAC>.cfg
Description
It enables or disables the Teams phone to obtain IPv6 network settings via SLAAC
(Stateless Address Autoconfiguration).
Note: It works only if “static.network.ipv6_internet_port.type” is set to 0 (DHCP).