| Phone Network | 23
Description
It configures the VLAN priority for the PC port.
7 is the highest priority, 0 is the lowest priority.
Note: It works only if “static.network.pc_port.enable” is set to 1 (Auto Negotiation)
and “static.network.vlan.pc_port_enable” is set to 1 (Enabled). It is not applicable to
CP960 Phones.
Permitted Values Integer from 1 to 7
Default 0
Web UI Network > Advanced > VLAN > PC Port > Priority
Phone UI
> Settings > Device Settings > Network(Admin only, default password:
admin) > VLAN > PC Port > Priority
[1]If you change this parameter, the phone will reboot to make the change take effect.
DHCP VLAN
Yealink Teams IP Phones support VLAN discovery via DHCP. When the VLAN discovery method is set to DHCP,
the phone will examine DHCP option for a valid VLAN ID. The predefined option 132 is used to supply the VLAN
ID by default. You can customize the DHCP option used to request the VLAN ID.
The following table lists the parameters you can use to configure DHCP VLAN discovery.
Parameter static.network.vlan.dhcp_enable
[1]
<y0000000000xx>.cfg
Description It enables or disables the DHCP VLAN discovery feature on the phone.
Permitted Values
0-Disabled
1-Enabled.
Default 1
Web UI Network > Advanced > DHCP VLAN > Active
Phone UI
> Settings > Device Settings > Network(Admin only, default password:
admin) > DHCP VLAN
Parameter static.network.vlan.dhcp_option
[1]
<y0000000000xx>.cfg
Description
It configures the DHCP option from which the phone obtains the VLAN settings.
You can configure at most five DHCP options and separate them by commas.
Permitted Values Integer from 1 to 255
Default 6132
Web UI Network > Advanced > DHCP VLAN > Option(1-255)
Phone UI
> Settings > Device Settings > Network(Admin only, default password:
admin) > DHCP VLAN > Option
[1]If you change this parameter, the phone will reboot to make the change take effect.
VLAN Setting Configuration
The following table lists the parameter you can use to configure VLAN setting.
To Next Page
Loading...
Need help?
General
