| Phone Network | 26
Parameter static.wifi.X.eap_type
[2]
<y0000000000xx>.cfg
Description It configures the EAP authentication mode of a specific wireless network.
Note:It works only if "static.wifi.function.enable" and "static.wifi.enable" are set to 1
(Enabled).
Permitted Values TTLS, PEAP or TLS
Default Blank
Parameter static.wifi.X.eap_user_name
[2]
<y0000000000xx>.cfg
Description It configures the EAP authentication username of a specific wireless network.
Note:It works only if "static.wifi.function.enable" and "static.wifi.enable" are set to 1
(Enabled).
Permitted Values String within 64 characters
Default Blank
Parameter static.wifi.X.eap_password
[2]
<y0000000000xx>.cfg
Description It configures the EAP authentication password of a specific wireless network.
Note:It works only if "static.wifi.function.enable" and "static.wifi.enable" are set to 1
(Enabled).
Permitted Values String within 64 characters
Default Blank
[1] If you change this parameter, the phone will reboot to make the change take effect.
[2] X is Wi-Fi ID. X=1-5.
Internet Port and PC Port
Yealink Teams IP Phones support two Ethernet ports: Internet port and PC port. You can enable or disable the PC port
on the phones. PC port is not applicable to CP960 Phones.
•
Supported Transmission Methods
•
Internet Port and PC Port Configuration
Supported Transmission Methods
Three optional methods of transmission configuration for the phone Internet port and PC port:
• Auto Negotiation
• Half-duplex (transmit in 10Mbps or 100Mbps)
• Full-duplex (transmit in 10Mbps, 100Mbps or 1000Mbps(not applicable to CP960 phones))
Auto-negotiate is configured for both Internet and PC ports on the phone by default.
Internet Port and PC Port Configuration
The following table lists the parameters you can use to configure Internet port and PC port.
Parameter static.network.pc_port.enable
[1]
<y0000000000xx>.cfg
To Next Page
Loading...
Need help?
General
