| Phone Network | 21
Description It enables or disables the CDP (Cisco Discovery Protocol) feature on the phone.
Permitted Values
0-Disabled
1-Enabled, the phone will attempt to determine its VLAN ID through CDP.
Default 1
Web UI Network > Advanced > CDP > Active
Phone UI
> Settings > Device Settings > Network(Admin only, default password:
admin) > CDP > CDP Status
Parameter static.network.cdp.packet_interval
[1]
<y0000000000xx>.cfg
Description
It configures the interval (in seconds) at which the phone sends the CDP (Cisco
Discovery Protocol) request.
Note: It works only if “static.network.cdp.enable” is set to 1 (Enabled).
Permitted Values Integer from 1 to 3600
Default 60
Web UI Network > Advanced > CDP > CDP Interval (1~3600s)
Phone UI
> Settings > Device Settings > Network(Admin only, default password:
admin) > CDP > CDP Interval
[1]If you change this parameter, the phone will reboot to make the change take effect.
Manual VLAN Configuration
VLAN is disabled on the phones by default. You can configure VLAN for the Internet port and PC port manually.
Before configuring VLAN on the phone, you need to obtain the VLAN ID from your network administrator. PC port
is not applicable to CP960, you can only configure VLAN for the Internet port manually.
The following table lists the parameters you can use to configure VLAN manually.
Parameter static.network.vlan.internet_port_enable
[1]
<y0000000000xx>.cfg
Description It enables or disables the VLAN for the Internet port.
Permitted Values
0-Disabled
1-Enabled
Default 0
Web UI Network > Advanced > VLAN > WAN Port > Active
Phone UI
> Settings > Device Settings > Network(Admin only, default password:
admin) > VLAN > WAN Port
Parameter static.network.vlan.internet_port_vid
[1]
<y0000000000xx>.cfg
Description
It configures the VLAN ID for the Internet port.
Note: It works only if “static.network.vlan.internet_port_enable” is set to 1 (Enabled).
Permitted Values Integer from 1 to 4094
Default 1
To Next Page
Loading...
Need help?
General
