Yealink Teams Series

| Phone Network | 16
Permitted Values
0-Disabled
1-Enabled
Default 1
Web UI Network > Advanced > ICMPv6 Status > Active
[1]If you change this parameter, the phone will reboot to make the change take effect.
DHCP Option for IPv4
The Teams phone can obtain IPv4-related parameters in an IPv4 network via DHCP option.
Note: For more information on DHCP options, refer to RFC 2131 or RFC 2132.
•
Supported DHCP Option for IPv4
•
DHCP Option 160 and Option 161
•
DHCP Option 66 , Option 43 and Custom Option
•
DHCP Option 42 and Option 2
•
DHCP Option 12
•
DHCP Option 60
Supported DHCP Option for IPv4
The following table lists common DHCP options for IPv4 supported by Teams IP Phones.
Parameter DHCP Option Description
Subnet Mask 1 Specify the client’s subnet mask.
Time Offset 2 Specify the offset of the client's subnet in seconds
from Coordinated
Universal Time (UTC).
Router 3 Specify a list of IP addresses for routers on the
client’s subnet.
Time Server 4 Specify a list of time servers available to the client.
Domain Name Server 6 Specify a list of domain name servers available to
the client.
Log Server 7 Specify a list of MIT-LCS UDP servers available to
the client.
Host Name 12 Specify the name of the client.
Domain Server 15 Specify the domain name that client should use
when resolving hostnames via DNS.
Broadcast Address 28 Specify the broadcast address in use on the client's
subnet.
Network Time Protocol
Servers
42 Specify a list of NTP servers available to the client
by IP address.
Vendor-Specific Information 43 Identify the vendor-specific information.
Vendor Class Identifier 60 Identify the vendor type.