| Basic Settings | 122
Parameter Description Configuration Method
DST Start Month
DST Start Day of Week
DST Start Day of Week Last in
Month
Start Hour of Day
When you select By Week as
the fixed type, configures the
start time of DST.
Note: It only works when you
enable Daylight Saving Time.
Web user interface
DST Stop Month
DST Stop Day of Week
DST Stop Day of Week Last in
Month
End Hour of Day
When the DST calculation
method is set to By month,
configures the end month of
DST.
Note: It only works when you
enable Daylight Saving Time.
Web user interface
Offset(minutes)
Specify the DST offset time (in
minutes).
Valid value: from -300 to +300.
Note: It only works when you
enable Daylight Saving Time.
Web user interface
Manually Configuring the Time and Date
You can set the time and date manually when the system cannot obtain the time and date from the NTP
time server.
Procedure
1. Do one of the following:
• On your web user interface, go to Setting > Date&Time.
• On your VCS, go to More > Settings > Basic > General > Date & Time.
For VP59, tap Settings > Basic > Date & Time.
•
On your CTP20/CTP18, tap > Settings > Basic > General > Date & Time.
2. Configure and save the following settings:
Parameter Description Configuration Method
Manual Time/Time Type Select On/Manual Setting to
obtain the time and date from
the NTP server automatically.
Web user interface
Endpoint
CTP20/CTP18
3. Configure the time and date.
4. Save the change.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
