1-5
IM MX100-01E
Explanation of Functions
PC Software
The MX100 Standard Software comes standard. It allows one MX100 Data Acquisition
Unit to be connected to a PC and performs measurement data acquisition. The MX100
Standard Software consists of the three software programs below. For details about the
software functions and operating procedures, see the MX100 Standard Software User’s
Manual. When configuring a system using the MX100, the software release number and
hardware style number matching conditions must be met (see page i, “Notes”).
Integration Monitor
Enables you to connect or disconnect communications, configure acquisition conditions
and display conditions of the measurement channels, set up computations channels,
monitor measured and computed data, save measured and computed data, and carry
out other operations.
Viewer
Enables you to (1) display measured and computed data that has been stored, (2)
read values and perform computation over an area using cursors, and (3) convert the
measured and computed data into various file formats such as Excel.
Calibrator
This program is used to calibrate the MX100’s universal input modules, four-wire RTD
resistance input modules, strain input modules, and analog output modules.
1.1 Overview of the MX100 Data Acquisition Unit
To Next Page
Loading...
