YOKOGAWA MX100 User Manual

4-24
IM MX100-01E
4.10 8-CH, Medium-Speed PWM Output Module
Specificaions
Style number: S2
Number of outputs: 8
Update interval: 100 ms minimum (not synchronized to the measurement interval)
Output interval: 1 ms to 300 s (can be set channel by channel)
However,
1 ms intvl settg rng: 1 ms-30.000 s can be set in units of 1 ms
10 ms intvl settg rng: 10 ms-30.000 s can be set in units of 10 ms
Output types: Pulse width
Update timing: After receiving change command, duty is changed from falling
edge of the next interval
Pulse interval accuracy:
±100ppmofsetting
External power supply:
4 to 28V
Insulationresistance: 20MΩormore(500VDC)betweenoutputterminalandearth
Across output terminals: non-isolated
Withstand voltage: 2300 VAC (50/60 Hz) for one minute between the output terminal
and earth
Across output terminals: non-isolated
Duty resolution: 1 ms interval setting range: 12000
10 ms interval setting range: 60000
 However,thePCsoftwaresets0to100.000%(0.001%resolution)
 MXmainunit/API,sets0-100%with0to00000count.
Dutyaccuracy(loadresistanceat100Ωorless):
1 ms freq. setting rng: the longer of
±0.017%or±2 ms
10 ms freq. setting rng: the longer of
±0.0035%or±2 ms
 Iftheloadimpedanceisgreaterthan100Ω,theoutputdutymay
vary.
Output format: External power supply sourcing
ONresistance: 2Ωorless(however,whenoutputcurrentis200mAormore.)
Output capacity: 1A/ch max, however, 4 A or less total for all modules
*, **
* A 1A current limit circuit is built in to the output circuit. Once the current limit circuit is ON, the
circuit continues to operate unless the external power supply is turned OFF (maintains the
output off status). Once the external power supply has been turned OFF, restart the external
power supply after checking the load status.
** This module has a built-in fuse. The built-in fuse protects against fires or abnormal
emmissions of heat due to load shortages or other abnormalities. It does not protect against
damage to internal circuits.
Power consumption: Approx. 2.5 W (not including power consumption of external
power supply)
Terminal type: Clamp, attached and removed in units of 4 channels
Applicable wire size: 0.08 to 2.5 mm
2
(AWG28 to 12)
External dimensions: Approx. 57 (W) × 131 (H) × 151 (D) mm (including the terminal
cover)
Weight: Approximately 0.5 kg

YOKOGAWA MX100 Specifications

General

Brand	YOKOGAWA
Model	MX100
Category	Data Loggers
Language	English