help Output command help
Function Outputs command help. If a command name is specified as a parameter, a
simple explanation of its usage is output.
Setting
help[, p1]
(p1: specifies the command name for outputting help. con, eth, help, net,
or quit)
Example 1
help
EA
03/01/01 00:02:45.490
Command Help
con - echo connection status
eth - echo ethernet statistics
help - echo help
net - echo network statistics
quit - close this connection
EN
Example 2
help, help
EA
help[, <command name>] - echo help
EN
Description Outputs a command help or a description of how to use the command in a
form enclosed by EA and EN. If an invalid command is specified, an error
is output in the form “E1 Unknown command (CR+LF).”
net Output other network information
Function Outputs settings and statistical information (APP, TCP, and DLC) specific
to the MX100. The output value is a value at the time the MX100 is
powered up or a summed value after the MX100 is powered up.
Setting
net
Example
net
EA
03/01/01 00:02:45.490
Network Statistics
APP: applalive = 180 sec
TCP: keepalive = disable
TCP: connects = 1
TCP: closed = 1
TCP: timeoutdrop = 0
TCP: keepdrops = 1
TCP: sndtotal = 5
TCP: sndbyte = 71
TCP: sndrexmitpack = 0
TCP: sndrexmitbyte = 0
TCP: rcvtotal = 10
TCP: rcvbyte = 5
DLC: 16 collisions = 0
DLC: speed = 100 Mbps
EN
3.5 MX100 Maintenance and Test Using Communication Commands
To Next Page
Loading...
